Sea Stacks Made SIMPLE: How Caves, Arches, Stacks and Stumps Form

Sea stacks are isolated columns of rock standing in the sea just off a headland, separated from the mainland by marine erosion. They form at the end of a sequence that begins with a crack in a cliff and passes through a cave and an arch.

Diagram showing how sea stacks form on a headland through the crack, cave, arch, stack and stump sequence
The six stages in the formation of sea stacks on a headland.

What are sea stacks?

A sea stack is a tall, steep-sided pillar of rock that has been cut off from the coastline by the sea. Sea stacks are erosional landforms, which means they are created by the removal of rock rather than the build-up of sediment. They are usually found close to headlands, where resistant rock juts out into the sea and is attacked by waves from several directions.

Most sea stacks are made of rock that is hard enough to stand as a vertical column but that also contains lines of weakness. Chalk, limestone and well-jointed sandstone are typical examples. The joints, faults and bedding planes in these rocks give the sea a place to begin its attack.

In exam terms, sea stacks belong to the cave–arch–stack–stump sequence. Examiners expect students to explain every stage, name the erosion processes involved and refer to a real example.

Key terms to learn

TermDefinition
HeadlandA section of resistant rock that sticks out into the sea, with water on three sides
Joint / faultA natural crack or line of weakness in rock that erosion can exploit
Wave-cut notchAn undercut at the base of a cliff between high and low tide, formed by erosion
CaveA hollow eroded into a headland along a line of weakness
ArchAn opening that passes right through a headland, formed when caves meet or a cave breaks through
StackAn isolated pillar of rock left when the roof of an arch collapses
StumpThe low remains of a stack, often only visible at low tide

Where do sea stacks form?

Sea stacks form on high-energy, erosional coastlines. These coasts face a long fetch, so waves arrive with a lot of energy, and they are dominated by destructive waves that remove material rather than deposit it. The north-east and south-west coasts of England, the Orkney Islands and the south coast of Australia are all good examples of this type of environment.

Geology is the other key control. Stacks are most common on a discordant coastline, where alternating bands of hard and soft rock run at right angles to the sea and the softer rock is eroded more quickly into bays, leaving the harder rock as headlands. Students can read more about this process in the guide to headlands and bays.

Once a headland has formed, it is exposed to wave attack on three sides. Wave refraction concentrates wave energy on the headland, which is why caves, arches and stacks so often appear there rather than in the sheltered bays.

Rock types that produce sea stacks

  • Chalk – a soft but well-jointed limestone that forms dramatic white stacks, such as Old Harry Rocks and The Needles.
  • Carboniferous limestone – heavily jointed and vulnerable to solution, producing stacks along coasts such as those of south Wales.
  • Sandstone – where it is strongly bedded and jointed, it can form very tall stacks, such as the Old Man of Hoy in Orkney.
  • Volcanic rocks – basalt and other igneous rocks can form stacks where columnar jointing or dykes create lines of weakness.

The erosion processes that create sea stacks

Four marine erosion processes work together to create sea stacks. Each one attacks the rock in a different way, and an exam answer that names and explains the relevant processes will score more highly than one that simply says “the sea erodes the rock”. The guide to the four types of erosion covers these in more depth.

Hydraulic action

Hydraulic action is the force of the water itself hitting the cliff. When a wave breaks against a crack, air is trapped and compressed inside it, then expands rapidly as the wave retreats. This repeated compression and release weakens the rock and widens the crack, making hydraulic action vital in the early stages.

Abrasion

Abrasion (sometimes called corrasion) happens when waves pick up sand, pebbles and boulders and hurl them against the cliff. This acts like sandpaper, scraping and chipping away at the base of the cliff and the walls of caves. Abrasion is especially effective during storms, when waves are carrying a large load.

Attrition

Attrition is when rocks and pebbles carried by the waves knock against each other, becoming smaller and more rounded. Attrition does not erode the cliff directly, but it breaks down the debris that falls from caves, arches and stacks, allowing it to be removed by the sea.

Solution

Solution (or corrosion) is the chemical dissolving of rock by seawater. It is particularly important on chalk and limestone coasts, because calcium carbonate dissolves in slightly acidic water. Solution widens joints and helps to weaken the rock from within.

Weathering

Weathering also plays a part above the reach of most waves. Freeze-thaw, salt and biological weathering weaken the rock, making the roof of an arch or the top of a stack more likely to collapse.

How do sea stacks form? The step-by-step sequence

The formation of sea stacks is a classic sequence question. The best answers describe each stage in order, use correct terminology and explain *why* each change happens, not just *what* happens. The six stages below explain the sequence labelled in the diagram above.

  1. Crack – A headland made of resistant rock contains joints and faults. Waves attack these lines of weakness through hydraulic action and abrasion, and the crack begins to widen.
  2. Cave – Continued erosion enlarges the crack into a cave at the base of the headland, roughly between the high and low tide marks.
  3. Arch – The cave is eroded further back until it breaks through to the other side of the headland, or two caves on opposite sides meet. This creates an arch.
  4. Arch widens – Erosion at the base of the arch, combined with weathering of the roof, makes the opening wider and the roof thinner and weaker.
  5. Stack – Eventually the roof of the arch collapses under its own weight. The seaward side is left standing as an isolated pillar of rock: a stack.
  6. Stump – Waves erode a wave-cut notch around the base of the stack. In time, the stack topples over, leaving a low stump that may only be visible at low tide.

This sequence explains why sea stacks are always temporary features. Each stack is gradually eroded into a stump, while new caves and arches continue to form in the retreating headland behind it.

Why the roof of the arch collapses

Students often lose marks by stating that “the arch collapses” without an explanation. The roof of an arch collapses because erosion at the base widens the arch while weathering weakens the roof from above. As more rock is removed, the roof can no longer support its own weight and it falls into the sea.

Factors affecting how quickly sea stacks form

The speed at which caves, arches and stacks develop varies from one coastline to another.

FactorEffect on the rate of erosion
Rock typeSofter rock such as chalk erodes faster than very hard rock such as granite
Rock structureRock with many joints, faults and bedding planes is eroded more quickly
Wave energyLong fetch and strong prevailing winds give powerful destructive waves
Storm frequencyStorm waves carry more load, so abrasion and hydraulic action increase
WeatheringFreeze-thaw and salt weathering weaken the upper parts of arches and stacks

Wave type is closely linked to wave energy. Coasts that are dominated by high, steep waves with a strong backwash erode more quickly. The guide to constructive and destructive waves explains how to tell the two apart.

Famous examples of sea stacks around the world

Naming a specific example, and the rock type it is made from, adds valuable detail to an exam answer.

  • Old Harry Rocks, Dorset, England – chalk stacks at the end of the Purbeck headland at Handfast Point.
  • The Needles, Isle of Wight, England – a line of three chalk stacks that continue the same band of chalk as Old Harry Rocks.
  • The Old Man of Hoy, Orkney, Scotland – a very tall sandstone stack standing off the cliffs of Hoy.
  • The Twelve Apostles, Victoria, Australia – limestone stacks along the Great Ocean Road; one collapsed in 2005, showing how active this coastline is.
  • Ko Tapu, Phang Nga Bay, Thailand – a slender limestone stack, often called “James Bond Island”.
  • Flamborough Head, Yorkshire, England – a chalk headland with caves, arches and stacks.

Case study: Old Harry Rocks, Dorset

The stacks stand off Handfast Point, at the eastern end of the Isle of Purbeck in Dorset, on the Jurassic Coast. Students can find a full overview in the dedicated guide to Old Harry Rocks.

Geology

The headland at Handfast Point is made of chalk, a relatively resistant rock compared with the softer clays and sands found in Studland Bay to the north and Swanage Bay to the south. This difference in resistance has produced a classic discordant coastline, with the chalk standing out as a headland between two bays.

The same band of chalk once continued across to the Isle of Wight, where it now forms The Needles. Marine erosion and rising sea level after the last glacial period broke through this ridge of chalk, separating the two areas. The guide to the Dorset coast provides wider context.

Landforms at Handfast Point

The headland shows every stage of the erosion sequence in one place: caves and arches can be seen in the cliffs, while the main stack, known as Old Harry, stands just offshore. A smaller stump nearby is known as Old Harry’s Wife. The original stack of that name is widely reported to have collapsed in the late nineteenth century, leaving only a stump.

This makes Old Harry Rocks an ideal example for explaining how stacks form and then collapse. It shows clearly that the sequence is continuous: as one stack becomes a stump, new arches and stacks develop as the headland retreats.

Sea stacks: frequently asked questions

Are sea stacks erosional or depositional landforms?

Sea stacks are erosional landforms. They are created when the sea removes rock from a headland through hydraulic action, abrasion and solution, rather than by the build-up of sediment.

What is the difference between a stack and a stump?

A stack is a tall, isolated pillar of rock. A stump is the much lower remains of a stack after it has collapsed, and it is often covered by the sea at high tide.

How long do sea stacks take to form?

Sea stacks usually take hundreds to thousands of years to form, depending on the rock type, the number of joints and faults, and the energy of the waves. Collapses, however, can happen suddenly, often during storms.

Why do sea stacks form on headlands?

Headlands stick out into the sea, so they are attacked by waves on three sides. Wave refraction also concentrates wave energy onto headlands, which speeds up erosion.

What is a famous example of sea stacks in the UK?

Old Harry Rocks in Dorset and The Needles on the Isle of Wight are the best-known chalk examples. The Old Man of Hoy in Orkney is a famous sandstone example.

Sea stacks: key takeaways

  • Sea stacks are isolated pillars of rock separated from a headland by marine erosion.
  • They form on high-energy coasts, usually where resistant rock forms a headland on a discordant coastline.
  • Hydraulic action and abrasion are the main erosion processes, helped by solution and weathering.
  • The sequence is crack, cave, arch, stack and stump.
  • The roof of an arch collapses because erosion widens the base while weathering weakens the roof.
  • A wave-cut notch at the base of a stack eventually causes it to collapse into a stump.
  • Old Harry Rocks in Dorset is an excellent chalk case study showing every stage of the sequence.
  • Exam answers should use correct terminology, explain each stage in order and include a named example.

To conclude

Sea stacks are a clear example of how the sea shapes the coastline over time. They develop through a predictable sequence of crack, cave, arch, stack and stump, controlled by rock type, geological structure and wave energy. Learning this sequence, along with a named example such as Old Harry Rocks, gives students a strong foundation for questions on coastal landforms.

For further background on coastal geology and landforms, the British Geological Survey and National Geographic Education both provide reliable information on how sea stacks and other coastal features develop.

Dr Hayley Stainton

About the author

Dr Hayley Stainton is an educator, examiner and the founder of The Geography Teacher. She has a PhD and more than 20 years’ experience teaching at school and university level. Read more about Hayley